Indicator lights and warning lights

ZAU0S685.png
  1. Left turn signal indicator light “SBL00652.png”
  2. Right turn signal indicator light “SBL00651.png”
  3. High beam indicator light “SBL00648.png”
  4. Neutral indicator light “SBL00653.png”
  5. Stability control indicator light “SBL00647.png”
  6. Auxiliary system warning light “SBL00646.png”
  7. ABS warning light “SBL00655.png”
  8. Fuel level warning light “SBL00644.png”
  9. Oil pressure and Coolant temperature warning light “SBL00645.png”
  10. Engine trouble warning light “SBL00650.png”
  11. Cruise control indicator lights “SBL00833.png” /“SBL00832.png”

Turn signal indicator lights “SBL00652.png ” and “SBL00651.png”

Each indicator light will flash when its corresponding turn signal lights are flashing.

Neutral indicator light “SBL00653.png”

This indicator light comes on when the transmission is in the neutral position.

High beam indicator light “SBL00648.png”

This indicator light comes on when the high beam of the headlight is switched on.

Fuel level warning light “SBL00644.png”

This warning light comes on when the fuel level drops below approximately 2.7 L (0.71 US gal, 0.59 Imp.gal) . When this occurs, refuel as soon as possible.

The electrical circuit of the warning light can be checked by turning the vehicle on. The warning light should come on for a few seconds, and then go off.

If the warning light does not come on at all, remains on after refueling, or if the warning light flashes repeatedly, have a Yamaha dealer check the vehicle.

Cruise control indicator lights “SBL00833.png” /“SBL00832.png”

These indicator lights come on when the cruise control system is activated. (See page .)

When the vehicle is turned on, these lights should come on for a few seconds and then go off. Otherwise, have a Yamaha dealer check the vehicle.

Engine trouble warning light “SBL00650.png”

This warning light comes on if a problem is detected in the engine. If this occurs, have a Yamaha dealer check the on-board diagnostic system.

When the vehicle is turned on, this light should come on for a few seconds and then go off. Otherwise, have a Yamaha dealer check the vehicle.

ABS warning light “SBL00655.png”

In normal operation, the ABS warning light comes on when the vehicle is turned on, and goes off after traveling at a speed of 5 km/h (3 mi/h) or higher.

If the warning light does not work as described above, or if the warning light comes on while riding, the ABS may not work correctly. Have a Yamaha dealer check the vehicle as soon as possible.

If the ABS warning light does not turn off after reaching 5 km/h (3 mi/h), or if the warning light comes on while riding:

  • Use extra caution to avoid possible wheel lock during emergency braking.
  • Have a Yamaha dealer check the vehicle as soon as possible.

Stability control indicator light “SBL00647.png”

This indicator light flashes when the traction control system, SCS, or LIF systems engage while riding. When “TCS-MODE” is set to “OFF”, the indicator will come on.

When the vehicle is turned on, this light should come on for a few seconds and then go off. If the light does not come on, or if the light remains on, have a Yamaha dealer check the vehicle.

When turning the main switch on, avoid any movement or vibration of the vehicle as it may interfere with the initialization of the IMU. If this occurs, the traction control system will not operate and the “TCS-MODE” display will read “OFF” until the IMU can initialize.

Oil pressure and Coolant temperature warning light “SBL00645.png”

This warning light comes on if the engine oil pressure is low or if the coolant temperature is high. If this occurs, stop the engine immediately.

  • When the vehicle is first turned on, this light should come on until the engine is started.
  • If a malfunction is detected, this light will come on and the oil pressure icon will flash.

If the oil pressure and coolant warning light does not go off after starting the engine or if it comes on while the engine is running, stop the vehicle and engine immediately.

  • If the engine is overheating, the coolant temperature warning icon will come on. Let the engine cool. Check the coolant level (see page ).
  • If the engine oil pressure is low, the oil pressure warning icon will come on. Check the oil level (see page ).
  • If the warning light remains on after letting the engine cool and confirming the proper oil level, have a Yamaha dealer check the vehicle. Do not continue to operate the vehicle!

Auxiliary system warning light “SBL00646.png”

This warning light comes on if a problem is detected in a non-engine-related system.

When the vehicle is turned on, this light should come on for a few seconds and then go off. Otherwise, have a Yamaha dealer check the vehicle.