Starting the engine

  1. Turn the key to “SBL00258.png” (on).

  2. Confirm the indicator and warning light(s) come on for a few seconds, and the go off.

    The EPS warning light should go off after the engine is started.

    If a warning or indicator light does not work as described above, have a Yamaha dealer check the vehicle.

  3. Apply the brake pedal.

  4. Shift the drive select lever into the neutral position.

    • The engine can be started in any gear if the brake pedal is applied. However, it is recommended to shift into neutral before starting the engine.

  5. With your foot off the accelerator pedal, start the engine by turning the key to “SBL00348.png” (start).

If the engine fails to start, release the key, and then try starting it again. Wait a few seconds before the next attempt. Each attempt should be as short as possible, to preserve battery energy. NOTICE: Do not crank the engine more than 5 seconds on each attempt, or starter damage could occur. Wait at least 5 seconds between each operation of the electric starter to let it cool.

Do not turn the key to the “SBL00348.png” (start) position with the engine running; otherwise, damage to the electric starter may result.

  • Engine power is restricted when the engine is too cold.
  • For maximum engine life, never accelerate hard when the engine is cold!