Starting the engine
The ignition circuit cut-off system will enable starting when:
- the transmission is in the neutral position or
- the transmission is in gear, the sidestand is up, and the clutch lever is pulled.
To start the engine
Turn the main switch on and set the engine stop switch to the run position.
Confirm the indicator and warning light(s) come on for a few seconds, and then go off.
- Do not start the engine if the engine trouble warning light remains on.
- The oil pressure warning light should come on and stay on until the engine is started.
- The ABS warning light should come on and stay on until the vehicle reaches a speed of 10 km/h (6 mi/h).
If a warning or indicator light does not work as described above, have a Yamaha dealer check the vehicle.
Shift the transmission into the neutral position.
Start the engine by pushing the start switch.
Release the start switch when the engine starts, or after 5 seconds. Wait 10 seconds before pressing the switch again to allow battery voltage to restore.
For maximum engine life, never accelerate hard when the engine is cold!
This model is equipped with:
- a lean angle sensor. This sensor stops the engine in case of a vehicle turnover. If this happens, the engine trouble warning light will come on, but this is not a malfunction. Turn the vehicle power off and then back on again to cancel the warning light. Failing to do so will prevent the engine from starting even though the engine will crank when pushing the start switch.
- an engine auto-stop system. The engine stops automatically if left idling for 20 minutes. If the engine stops, simply push the start switch to restart the engine.